LEMORELE™ P1 | Transmisor y receptor HDMI inalámbrico HDMI a HDMI inalámbrico

A: Yes, but it depends on the device model. In general, HDMI and USB-C transmitters can pair with receivers of the same model, while USB-A transmitters require a driver and do not support pairing with receivers of other interfaces.

A: No, pairing is not necessary. The wireless casting kit has been pre-paired before leaving the factory. Once the kit is properly connected, it will automatically connect and be recognized.

A: You can restore the receiver to factory settings by pressing and holding the button on the side of the receiver or using a pin to press and hold the reset hole for more than 10 seconds.

A: If you need to use multiple sets of devices for transmission in the same room, it is recommended to use no more than 4 sets simultaneously to avoid interference from excessive signals that may cause connection issues.

A: Each wireless casting device is pre-paired before leaving the factory and uses point-to-point encrypted transmission. Unless manually re-paired, each transmitter (TX) will only connect to its corresponding receiver (RX) and will not interfere with other devices.